stroezie
Sub General
As usual life gets in the way of gaming
Posts: 224
|
Post by stroezie on Jan 14, 2014 11:34:02 GMT -5
I was recentely given an airbrush that was found on somebody's attic. It is a Badger no.200, it seems to be in good repair altough the airhose looks to have seen better days. Does anybody have any experience with this model? Can I use it for 15mm figures/vehicles and do I need a special compressor or can I use the one I have for my tools in the shed. Thanx.
|
|
|
Post by Mr. Harold on Jan 14, 2014 13:12:35 GMT -5
Not sure about the model, but the compressor should be fine as long as you can dial it down to 20 psi or so. You might also think about putting a water trap in line if you have a lot of humidity in the air, otherwise it might get in the air and cause sputtering.
|
|